JIMPIC(1)                        User Commands                       JIMPIC(1)



NAME
       jimpic - manual page for jimpic 1.9

SYNOPSIS
       jimpic [options]
               -------

DESCRIPTION
       -p, --port port
              specify the port address (default: auto)

       -c, --chip name
              specify chip (default: auto)

       -b, --burn file
              "fbp" mode: erase all, burn, and verify

       -R, --run
              run the PIC (set /MCLR high, PGM low)

       -S, --stop
              stop the PIC (set /MCLR low)

       -r, --read file
              read all memory, save in file

       -w, --write file
              write all memory from file

       -e, --erase
              erase program and data memory

       -E, --erase-all
              erase all memory, clear code protection

       -v, --verify file
              verify all memory from file

       -t, --test
              only test the hardware

       -s, --slow
              use slower delays

       -n, --nodata
              never touch the data memory

       -W, --writeonly
              never read from the PIC

       -V, --version
              show program version and exit

       -P, --power
              control power line on PIC burner

       -G, --go
              wait for signal on port before doing anything

       -h, --help
              this help

AUTHOR
       Written  by Jim Paris <jim@jtan.com>.  jimpic is free software; you can
       redistribute it and/or modify it and it is provided under the terms  of
       version  2  of  the GNU General Public License as published by the Free
       Software Foundation.



jimpic 1.9                       February 2006                       JIMPIC(1)